ttmacro - setrts command has no effect
TeraTerm Version used: 4.103 on a Windows 10 laptop.
Device is connected to the PC through an FTDI UART USB converter.
I'm trying to control the RTS line of the UARTby using the setrts command. But when I probe the RTS line, I observe no change on this signal.
Below the basic code used check setrts command behavior: force the flow control to hardware(RTS/CTS) and then toggle the RTS every 5 seconds
; Enable HW flow control (RTS/CTS)
; Toggle RTS every 5 seconds
dispstr "#RTS 1 "
dispstr "#RTS 0 "
Closed as invalid, like the HW flow control should be disbable to be able to change manually theRTS signal by setRTS command.
Works fine by changing